Transmission Output Shaft Seal, Replacing: Installing
WARNING: This page is about a different variant/trim than selected.
-- Lightly coat the outer edge of the seal.
-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.
-- Position the seal with the Assembly Device - Sleeve: T40367/1 .
-- Press in the seal all the way using the Assembly Device - Thrust Piece:T40367/2 .
-- Install the all-wheel drive clutch. Refer to ALL-WHEEL DRIVE CLUTCH, REMOVING AND INSTALLING .
-- Install the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .