LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Final Drive, Differential (Servicing - 7-Speed Dual Clutch Transmission 0CJ, 0CL, 0CK, 0DK, 0DN, 0DP, 0HL) (Coupe)) >> 39 Final Drive, Differential >> Center Differential >> Center Differential, Removing And Installing >> Removing

Center Differential, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

CAUTION:

Transmission components could be damaged.

  • The self-locking center differential is pretensioned with a pressure spring.
  • Carefully remove the center differential housing from the transmission toward the rear. Otherwise the center differential could fall out of the transmission.

-- Remove the bolts from the self-locking center differential housing in the following sequence: -11 to 1-.

Fig 1: Center Differential Housing - Tightening Sequence
GWWA39-10856Courtesy of AUDI OF AMERICA, LLC

-- Remove the oil guide piece.

GWWA39-10857Courtesy of AUDI OF AMERICA, LLC

-- Secure the center differential -1- so it does not fall out or remove it toward the rear from the input shaft.

Fig 2: Identifying Center Differential -1- At Input Shaft
GWWA39-10416Courtesy of AUDI OF AMERICA, LLC