Bumper Carrier Mount, Removing

WARNING: This page is about a different variant/trim than selected.

Courtesy of AUDI

-- Disconnect the connector -1- on the horn -2- and free up the wiring harness -3-.

-- Remove the bolts -arrows-.

Courtesy of AUDI

-- Remove the bolts -1 and 4-.

Courtesy of AUDI

-- Pull the lock carrier -3- slightly forward, push the bumper carrier mount -2- upward and out of the guide -5- -arrow- and remove it to the side.

Installing

Install in the reverse order of removal while noting the following:

-- Adjust the spring element. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .

Tightening Specifications