Overview - Bumper Carrier

Fig 1: Exploded View Of Bumper Carrier

Courtesy of AUDI

1. Molded Foam Part
   • Depending on the version
   • Removing and Installing. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
2. Bracket
   • For the Outside Air Temperature Sensor -G17-
3. Bolt
   • Depending on the version
   • 2.5 Nm
4. Outside Air Temperature Sensor -G17-
   • Removing and Installing. Refer to OUTSIDE AIR TEMPERATURE SENSOR -G17-, REMOVING AND INSTALLING .
5. Bumper Carrier
   • Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING .
6. Bolt
   • Quantity: 4
   • 55 Nm
7. Lock Carrier
8. Bolt
   • Quantity: 2
   • Tightening specification Refer to Fig 2.
9. Bolt
   • For securing the bumper carrier to the lock carrier
   • Quantity: 2
   • 14 Nm
10. Nut
    • Tightening specification. Refer to OVERVIEW - HORN .
11. Bracket with Horn
    • Removing and Installing. Refer to HIGH TONE HORN -H2- /LOW TONE HORN -H7-, REMOVING AND INSTALLING .
12. Bumper Carrier Mount
    • Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING .
13. Connecting Brace
    • Market-Specific Version
14. Bolt
    • Quantity: 2
    • 9 Nm
15. Nut
    • Quantity: 2
16. Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
    • Unit with pressure hose
    • Must be replaced when
      • Molded foam part visibly damaged
      • Bumper carrier visibly damaged
      • The bumper cover is deformed.
      • The pressure hose is damaged.
    • Removing and Installing. Refer to OVERVIEW - PEDESTRIAN PROTECTION .

Front bumper carrier - tightening specification and sequence

Fig 2: Front Impact Member

Courtesy of AUDI

-- Tighten the bolts -A- to 23 Nm in the following sequence: -1 through 4-.