Component Location Overview - Adaptive Cruise Control (Acc)

Fig 1: Adaptive Cruise Control Components

Courtesy of AUDI OF AMERICA, LLC

1. Retaining Plate
   • Removing and Installing. Refer to RETAINING PLATE FOR Control Module for Adaptive Cruise Control -J428- /Control Module 2 for Adaptive Cruise Control -J850-, REMOVING AND INSTALLING .
2. Bolt
   • 2.5 Nm
   • Quantity: 3
3. Clip
   • Cannot be removed without being damaged
   • Closed version
   • Note the installation position
4. Clip
   • Open version
   • Cannot be removed without being damaged
5. Stud Bolt
   • Note the adjustment dimension. Refer to Installing => Measure the dimension -a- at all stud bolts using the Digital Caliper:VAS6335 and correct if necessary. .
   • Quantity: 3
6. Clip
   • Must be replaced when the stud bolt is removed
   • Replacing. Refer to CLIP ON Control Module for Adaptive Cruise Control -J428-, REPLACING .
   • Quantity: 3
7. Distance Regulation Control Module
   • Right: Control Module for Adaptive Cruise Control -J428-
   • Left: Control Module 2 for Adaptive Cruise Control -J850-
   • Removing and Installing. Refer to Control Module for Adaptive Cruise Control -J428- /Control Module 2 for Adaptive Cruise Control -J850-, REMOVING AND INSTALLING .
   • Calibrate the adaptive cruise control (ACC). Refer to ADAPTIVE CRUISE CONTROL (ACC), ADJUSTING
8. Operating Lever for Adaptive Cruise Control
   • Shared component with the steering column switch module. Cannot be replaced separately
   • Removing and Installing. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
9. Instrument Cluster
   • With Instrument Cluster Control Module -J285-
10. Front Bumper
11. Clip
    • Open version
    • Cannot be removed without being damaged