ADDITIONAL WORK AFTER REPLACING FINAL DRIVE 0D3 "quattro sport" AND 0BX "quattro sport"

• If the rear final drive was replaced, the following additional work is necessary.

• Bleed the hydraulic control module using the Vehicle Diagnostic Tester .
• Program the rear final drive to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester .

• The additional work can only be performed when the rear final drive is replaced.

Procedure:

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 32 - Rear Final Drive Replacing  on the Vehicle Diagnostic Tester under Guided Functions  in the directory 32- Locking Electronics  .

• Follow all the instructions given by the Vehicle Diagnostic Tester exactly.

The new rear final drive is "adapted" to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester.

• A system check will take place when the function 32 - Rear Final Drive Replacing  is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.