ATF, Filling
WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- If no ATF leaks out of the ATF check and fill hole -arrow B- before the ATF reaches 40 °C (104 °F):
- At 45 °C (113 °F) the ATF inspection plug must be installed again. Let the transmission cool down and check again.
-- Install the :VAS6262/5 into the ATF check and fill hole -arrow-.
-- Fill the ATF using the adapter until the ATF starts to leak out of the check and fill hole.
-- Tighten the new plug -arrow B-. The ATF level test is now completed.
Tightening Specifications
- Drain and plug. Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS .
- Refer to OVERVIEW - NOISE INSULATION .