Overview - ATF Circuit, Version 2
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- ATF Hose Line
- Cleaning. Refer to Cleaning .
- Install all the way by hand with a new O-ring
- O-Ring
- If there are leaks replace the ATF hose line
- Coat with ATF before installing
- ATF Cooler
- Removing and Installing. Refer to ATF COOLER, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- O-Ring
- If there are leaks replace the ATF hose line
- Coat with ATF before installing
- O-Rings
- Replace
- Coat with ATF before installing
- Not installed
- Bolt
- 20 Nm
- First insert the ATF lines with new O-rings by hand as far as the stop
- The retaining tab on the lower ATF line must lie on the transmission threads
- The retaining tab on the upper ATF line must touch the lower one.
- ATF Hose Line
- Cleaning. Refer to Cleaning .
- Install all the way by hand with a new O-ring
- Bolt
- 8 Nm
Disconnect the ATF Line
-- Release the clip -1- from the connector coupling -2- in direction of -B arrows- and lift in direction of -A arrows-.
-- Remove the connector coupling.