Roller Bearing, Replacing: Removing
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Engine secured on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the crankshaft. Refer to OVERVIEW - CRANKSHAFT .
-- Remove the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
-- Install the Fitting Tool: T40395 on the correct side on the roller bearing.
- The bevel -arrow- faces the roller bearing.
-- Align the Adapter : T40395/3 .
- The side without the bevel -arrows- faces down.
-- Remove the front roller bearing -1- and rear roller bearing -2- inward using the Spindle : T40395/1 , Adapter: T40395/2 and Adapter : T40395/3 by turning the Nut: T40395/4 .
-- Remove the Fitting Tool: T40395 and remove the roller bearing.