Engine, Securing To Engine And Transmission Holder

Special tools and workshop equipment required 

• Engine and Gearbox Bracket VAS 6095A: VAS 6095A 
  Fig 1: Identifying Engine and Gearbox Bracket VAS6095A

  Courtesy of AUDI OF AMERICA, LLC
• Engine/Transmission Holder - Universal Mounting: VAS 6095/1  and V6 TFSI Engine Bracket: VAS 6095/1-15 
  Fig 2: Identifying Universal Mount VAS 6095/1

  Courtesy of AUDI OF AMERICA, LLC

Procedure 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the left engine support.

If the chain drive on the connection should be worked on:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2- at the same time to not damage it.

-- Free up the wiring harness -3-.

-- Remove the nuts -4- and bolt -5-.

-- Remove the vacuum reservoir -1-.

-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC

Continuation: 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ground cable nut -arrow-.

-- Remove the bolts -arrows- and remove the right engine support -1-.

Courtesy of AUDI OF AMERICA, LLC

-- On vehicles without a high-voltage system, remove the starter. Refer to STARTER, REMOVING AND INSTALLING .

-- Secure the engine to the Engine And Transmission Holder: VAS 6095A  using the Engine/Transmission Holder - Universal Mounting: VAS 6095/1  and Bracket For 3.0L TFSI: VAS 6095/1-15  and tighten to 40 Nm.

Courtesy of AUDI OF AMERICA, LLC