Component Location Overview - 48V System Wire Junction
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Mount
- For Suppressor -C24-
- Removing and Installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Suppressor -C24-
- Removing and Installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Cap
- Positive Cable
- To starter, generator
- Nut
- 16 Nm
- Positive Cable
- From the 12V battery
- Nut
- 20 Nm
- Terminal 30 Wire Junction 2 -TV22-
- Component Location Overview. Refer to Component Location Overview - and .
- Nut
- Tightening specification -item : Nut.
- Wire
- To the Suspension Stabilization Control Module 1 -J1152-
- Nut
- 20 Nm
- Wire
- To the Electric Compressor Control Module -J1123-
- Nut
- 9 Nm
- Terminal 40 Wire Junction -TV66-
- Removing and Installing. Refer to Terminal 40 Wire Junction -TV66-, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- Quantity: 2
- Nut
- 3 Nm
- Quantity: 3
- Terminal 30 Wire Junction -TV2-
- Removing and Installing. Refer to Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING, VEHICLES WITH 48V SYSTEM .