Ignition Coils, Removing And Installing, Cylinder Bank 1 (Right): Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring duct -1- for the EVAP system on the wiring duct -2-.

-- Free up the wiring duct and place it toward the rear.

-- Remove, disconnect and free up the connector from the bracket.

Courtesy of AUDI OF AMERICA, LLC

1. Equipment version with particulate filter: for the Exhaust Gas Temperature Sensor 3 -G495-
2. For the Oxygen Sensor 1 before Catalytic Converter -GX10-

-- Push the release buttons on both sides and remove the hoses -arrows- for the crankcase ventilation from he oil separator.

-- Remove the nuts -A arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors and free up the wires:

1. For the Fuel Metering Valve -N290-
2. For the Low Fuel Pressure Sensor -G410-
3. For the Engine Cover Temperature Sensor -G765-
4. For the Cylinder 2 Exhaust Cam Actuator 1 -F454- / Cylinder 3 Exhaust Cam Actuator 1 -F458-
5. For the Recirculation Valve, Bank 1 -N625-
6. For the ignition coils

-B arrows- for the fuel injectors

-- Push the wiring harness with wiring duct to the right side.

All additional procedures are described. Refer to IGNITION COILS, REMOVING AND INSTALLING .