Overview - Cylinder Block, Transmission Side
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- For assembly work secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
- Bolt
- 60 Nm +90°
- Replace after removing.
- Drive Plate
- With the bearing flange
- Check the contact surfaces on the bearing flange and the torque converter holes for cracks and wear grooves.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and Installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Check using the Vehicle Diagnostic Tester SENSOR WHEEL, CHECKING .
- After removing and installing or replacing perform the adaptations listed in the guided function "0001 - mechanical engine, functions" using the Vehicle Diagnostic Tester.
- Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Alignment Pin
- Crankshaft
- Overview. Refer to OVERVIEW - CRANKSHAFT .