Engine, Securing To Engine And Transmission Holder
Special tools and workshop equipment required
- Engine and Gearbox Bracket:VAS6095A
- Engine/Transmission Holder - Universal Mounting:VAS6095/1 and Bracket FOR 3.0L TFSI:VAS6095/1-15
Procedure
-- Remove the bolts -arrows- and the left engine support -1-.
If the chain drive on a 3.0L engine must also be worked on:
-- Remove the vacuum hose -2- at the same time to not damage it.
-- Free up the wiring harness -3-.
-- Remove the nuts -4- and bolt -5-.
-- Remove the vacuum reservoir -1-.
-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.
Continuation:
-- Remove the ground cable nut -arrow-.
-- Remove the bolts -arrows- and remove the right engine support -1-.
-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .
-- Secure the engine to the :VAS6095A using the :VAS6095/1 and :VAS6095/1-15 and tighten to 40 Nm.