Component Location Overview - Seals, 0DB, 0D2 And 0G1 / 0G2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Right Flange Shaft
- Removing and Installing. Refer to RIGHT SEAL, REPLACING .
- Final drive 0DB: the right and left flange shaft are identical
- Final drive 0D2: -Arrow a- shaft diameter approximately 40 mm
- Circlip
- Always replace.
- Right Protective Ring
- Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
- Right Seal
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Rear Final Drive
- Refer to FINAL DRIVE, REMOVING AND INSTALLING
- Left Flange Shaft
- Removing and Installing. Refer to LEFT SEAL, REPLACING .
- Final drive 0DB: the right and left flange shaft are identical
- Final drive 0D2: -Arrow B- shaft diameter approximately 32 mm
- Circlip
- Always replace.
- Left Protective Ring
- Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
- Left Seal
- Replacing. Refer to LEFT SEAL, REPLACING .
- Input Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Protective Ring on Flange/Driveshaft
- Replacing. Refer to FLANGE/DRIVESHAFT PROTECTIVE RING, REPLACING .
- Flange/Driveshaft
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING .
- Circlip