Flange/Driveshaft Protective Ring, Replacing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate: VW 401

Fig 1: Press Plate
Courtesy of AUDI OF AMERICA, LLC
Press Piece - Rod: VW 407

Courtesy of AUDI OF AMERICA, LLC
Press Piece - Multiple Use: VW 412

Fig 2: Identifying Press Piece - Multiple Use VW412
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Flange Shaft: T10049

Courtesy of AUDI OF AMERICA, LLC
-3- 22 to 75 mm Separating Tool, for example Splitter: VAS251411

Fig 3: Commercially Available Puller Set
Courtesy of AUDI OF AMERICA, LLC

Flange/driveshaft removed.

Press the protective ring off the flange/driveshaft.

Fig 4: Pressing Dust Cap Off Of Driveshaft Flange

Courtesy of AUDI OF AMERICA, LLC

A - 22 to 115 mm Separating Tool, for example Splitter: VAS251411

Install the protective ring arrow onto the flange/driveshaft.

Fig 5: Install the protective ring -arrow- onto the flange/driveshaft.

Courtesy of AUDI OF AMERICA, LLC

Installation position: ribbed side of the protective ring points to the flange.
The protective ring -A- must engage audibly in the groove on the flange.