COMPONENT LOCATION OVERVIEW - SEALS, 0B0 "quattro ultra"

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Rear Final Drive Seals, 0B0 "Quattro Ultra"

Courtesy of AUDI OF AMERICA, LLC

Bleed Cap
Circlip
- Always replace.
Left Flange Shaft
- Removing and Installing. Refer to LEFT SEAL, REPLACING, 0DB, 0D2, 0G2, 0DG, 0B0 "quattro ultra", 09R "quattro ultra" .
Left Protective Ring
- Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
Left Seal
- Replacing. Refer to LEFT SEAL, REPLACING, 0DB, 0D2, 0G2, 0DG, 0B0 "quattro ultra", 09R "quattro ultra" .
Circlip
Flange/Driveshaft
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING .
Protective Ring on Flange/Driveshaft
- Replacing. Refer to FLANGE/DRIVESHAFT PROTECTIVE RING, REPLACING .
Input Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
Rear Final Drive
- Refer to FINAL DRIVE, REMOVING AND INSTALLING
Right Seal
- Replacing. Refer to RIGHT SEAL, REPLACING, FINAL DRIVE 0B0 "quattro ultra" .
Right Protective Ring
- Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
Right Flange Shaft
- Removing and Installing. Refer to RIGHT SEAL, REPLACING, FINAL DRIVE 0B0 "quattro ultra" .
O-Ring
Shim
Circlip
- Always replace.