Overview - Belt Pulley Side Sealing Flange
- Seal
- For the belt pulley side crankshaft
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Sealing Flange, Belt Pulley Side
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Alignment Sleeve
- Bolt
- 9 Nm
- Oil Dipstick Tube
- Seals
- Replace after removing
- Alignment Sleeve
- O-Ring
- Replace after removing
Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 17- | 3 Nm |
| 2. | -1 to 17- | 90° additional turn |