Crankshaft Seal, Replacing, Belt Pulley Side
Special tools and workshop equipment required
- Puller - Crankshaft Seal: T40019
- Assembly Tool: T40320
Procedure
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Position the inner part of the Puller - Crankshaft Seal: T40019 flush with outer part and secure it with the knurled screw.
-- Lubricate the threaded head on the camshaft seal puller position it and install it as far as possible into the seal using force.
-- Loosen knurled thumb screw and turn inner portion against crankshaft until the seal is pulled out.
-- Secure the seal puller in a vise at the flat spots and remove the seal using pliers.
-- Clean the contact and sealing surface.
-- Mount the Assembly Tool - Guide Sleeve: T40320/2 onto the crankshaft and push the seal -1- into the belt pulley side sealing flange.
- The open side of seal faces the engine.
- Leave the Assembly Tool - Guide Sleeve: T40320/2 on the crankshaft for pressing in.
-- Position the Assembly Tool - Thrust Piece: T40320/1 with the bolt -1- for the vibration damper on the crankshaft.
-- Press the seal -2- in all the way.
Install in reverse order of removal. Note the following:
-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .