DTC Memory, Checking
Indicated on display
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 2 to select the "Check DTC Memory" function 02.
Indicated on display
| Rapid data transfer Q 02 - Check DTC Memory |
-- Press Q button to confirm input.
Display indicates the number of stored malfunctions, or "No DTC recognized" is displayed.
| X DTC recognized → |
-- Press → button.
Diagnostic trouble codes stored in DTC memory are displayed and printed out one after the other DTC table, DTC TABLE .
-- Press → button after last DTC has been displayed and printed.
If a malfunction has been recognized:
-- Select "End Output" function 06.
-- Switch ignition off and repair the malfunction.
-- Check DTC memory again and erase.
If there is a malfunction in the system that is not identified by the On Board Diagnostic program, carry out troubleshooting with Bosch Abs Tester: VAG1710 .