Part II
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
- Cylinder Head
- Only replace together with the cylinder head cover
- O-Ring
- Lubricate with engine oil
- Check for damage
- No replacement part: included in the cam adjustment actuator delivery package
- Cam Adjustment Actuator
- Cam Adjustment Actuator 1 -F366-
- Cam Adjustment Actuator 2 -F367-
- Cam Adjustment Actuator 3 -F368-
- Cam Adjustment Actuator 4 -F369-
- Cam Adjustment Actuator 5 -F370-
- Cam Adjustment Actuator 6 -F371-
- Cam Adjustment Actuator 7 -F372-
- Cam Adjustment Actuator 8 -F373-
- Removing and installing. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .
- Bring into the installation position. Refer to Installing - The cam adjustment actuator pin must be brought into the installation position. .
- Bolt
- 5 Nm
- Ball Pin
- 9 Nm
- For the engine cover
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Plugs
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Cam Position Sensor 3 -G300-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification -item 8) Bolt -.
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Always replace after removing.
- Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING
- Bolt
- Tightening specification. Refer to Vacuum System .
- Seal
- Always replace if damaged
- O-Ring
- Replace after removing.
- Coat with engine oil
- Cam Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification -item 13) Bolt -.
- Bolt
- 9 Nm
- Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-