Overview - Ignition System
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm + 90°
- Always replace after removing.
- The tightening specifications affect function of the knock sensor
- Knock Sensor 1 -G61-
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Spark Plug Connectors
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Nut
- 9 Nm
- Bolt
- 9 Nm
- Cam Position Sensor 3 -G300-
- Removing and installing. Refer to Cam Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Always replace if damaged
- O-Ring
- Always replace if damaged
- Cam Position Sensor -G40-
- Removing and installing. Refer to Cam Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Always replace if damaged
- Engine Speed Sensor -G28-
- Check the O-ring for damage
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4 Nm + 45°
- Always replace after removing.