Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the bolts that were tightened with an additional turn after removing them.
Manual transmission vehicles have a needle bearing inside the drive plate. Check before installing that the needle bearing is used. Remove needle bearing from drive plate and install. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Reposition the :10-201 to tighten the bolts.