Needle Bearing In Drive Plate, Replacing
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Piece - 31.5mm:VW418A
- Press Piece - 28x100mm:VW421
- Bearing Installer - Multiple Use:40-103
Only available with the manual transmission a needle bearing is installed in the drive plate.
Procedure
- The transmission is removed. Refer to the appropriate service information .
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Place the :40-103 under the drive plate to remove and install.
-- Press out the needle bearing using :VW421 and workshop press.
- The smaller diameter of :VW421 faces the drive plate.
-- Carefully press the needle bearing in all the way using :VW418A and workshop press.
- Installed position: the closed side of the needle bearing faces the engine.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .