Exhaust Gas Temperature Sensor, Removing And Installing, AWD Vehicles: Installing
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.
-- Bring the pre-particulate filter temperature sensor into its installation position:
- Angle -α- = maximum 15°.
-- Bring the angled post-particulate filter temperature sensor (on some versions) into its installation position:
- Angle -α- = maximum 15°.
There are additional procedures depending on the model. Refer to EXHAUST TEMPERATURE REGULATION COMPONENTS, REMOVING AND INSTALLING .