Overview - Drive Plate
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Block
- Transmission Side Sealing Flange
- With gasket
- Do not apply oil to the seal.
- Replacing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Before installing, remove oil residue from crankshaft journal with a clean cloth.
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Intermediate Plate
- Be careful not to damage or bend when installing
- Installing. Refer to Figure.
- Alignment Sleeve
- Bolt
- 60 Nm +90°
- Replace after removing
- Washer
- Drive Plate
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Only possible to install in one position - holes are offset -
- The >>collar<< faces the cylinder block
- Shim
- Usage. Refer to Installing .