Overview - Final Drive: Notes
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 60 Nm +180°
- Replace after removing
- Quantity: 3
- Buffer
- Place on the bonded rubber bushing. Refer to Figure.
- Washer
- Installation position: the bevel (smaller diameter) faces the subframe
- Bolts
- 60 Nm +180°
- Replace after removing
- Rear Subframe
- Buffers
- Place on the bonded rubber bushing. Refer to Figure.
- Rear Final Drive
- Removing and installing. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
- Bonded rubber bushing, removing and installing. Refer to OVERVIEW - SUBFRAME MOUNT .
- Depending on the version with balance weight. Refer to Balance Weight .