Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Position bolts by hand. While doing so, make sure that the bolts are not installed at an angle.

-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .

-- Remove the Engine Support Set:10-222B from the engine.

-- Install the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .