Assembly Mount, Checking Adjustment
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
The following dimensions must be attained:
- The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
- The casting edge on the engine support must be parallel to the engine mount support arm.
- Dimension -b- = dimension -b-.
TIP:
The distance -a- = 10 mm and can also be checked using for example a corresponding round stock.
-- If the distance measured is too small or too large, adjust the subframe. Refer to Refer to ASSEMBLY MOUNT, ADJUSTING .