Overview - Assembly Mounts

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Assembly Mounts

Courtesy of AUDI

1-7 - Engine Mount
- Refer to OVERVIEW - ASSEMBLY MOUNTS
8 - Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
9 - Bolt
- Tightening Specification. Refer to Fig 2.
- Always replace
10 - Bolt
- Tightening Specification. Refer to Fig 2.
- Always replace
11 - Bolt
- Tightening Specification. Refer to Fig 2.
- Always replace
12 - Bolt
- 60 Nm + 90°
- Always replace
13 - Bolt
- 60 Nm + 90°
- Always replace
14 - Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
15 - Bolt
- 50 Nm + 90°
- Always replace

Pendulum Support Tightening Specifications and Sequence

Fig 2: Engine Support Component Location

Courtesy of AUDI

-- Tighten the bolts in the steps in the sequence shown:

Step	Bolts	Tightening Specifications/Additional Turn
1.	-2 and 3-	60 Nm
2.	-1-	130 Nm
3.	-1 to 3-	90° additional turn