Battery -A-, REMOVING AND INSTALLING, Q3, 0K3: Installing
Install in the reverse order of removal while noting the following:
Batteries from the Audi Parts Program have a base strip adapter for conforming to different clamping strips. See the battery operating instructions for information on when and how to use the base strip adapter.
-- Insert the battery into the battery tray -1- so that the battery base strip touches the rear and side stop -arrows-.
- The battery must not be able to move at all anymore.
-- When the ignition and electrical equipment are switched off, connect the battery in the following sequence:
-- First connect the battery positive cable terminal to the battery positive terminal "+" by hand and tighten the nut.
-- Disconnect the connector -2- from the Battery Monitoring Control Module -J367- -3-.
-- Connect the battery ground cable clamp to the battery negative terminal "-" by hand and tighten the nut -1-.
-- Reconnect the connector to the Battery Monitoring Control Module -J367-.
- Pay attention to the position of the wires for the Battery Monitoring Control Module -J367- behind the securing strap.
-- Check the battery for secure fit after installation.
-- If the Battery -A- was replaced, then the new Battery -A- must be adapted.
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Select the Diagnostic mode and start the diagnosis.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-capable systems
- 0019 - Data Bus on Board Diagnostic Interface - J533
- 0019 - Data Bus on Board Diagnostic Interface, functions
- 0019 - Adaptation
- 0019 - Adapt battery
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
When the battery is reconnected, the following steps must be performed:
- Activate the one-touch up/down function for the power window regulators. Refer to the Owner's Manual.
- Check all the control module DTC memories and erase the displayed "undervoltage" entry using the Vehicle Diagnostic Tester.
TIP:
After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.
Tightening Specifications
- Refer to OVERVIEW - Battery -A-, Q3 (0K3)