All Wheel Drive Clutch, Removing And Installing: Installing

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal while. Note the following:

-- Remove the old O-ring -arrow- from the all wheel drive clutch.

-- Insert the new O-ring -arrow- and lightly lubricate with all wheel drive clutch oil.

-- Insert the all wheel drive clutch -1- in the rear final drive. Install :T10093  for exact guidance.

Fig 1: Haldex Clutch In Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- Rotate at flange/driveshaft -2- and insert all wheel drive clutch all the way in.

-- Tighten the bolts -arrows- to the tightening specification.

Fig 2: Identifying Haldex Clutch To Rear Final Drive Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -B- from the All Wheel Drive Control Module -J492- -A-.

The connector -C- must also be connected.

Courtesy of AUDI OF AMERICA, LLC

-- Attach the driveshaft to the rear final drive. Refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Align the intermediate bearing in the oblong holes so that neither the driveshaft nor the intermediate bearing are under stress.

-- Install the exhaust system and align it without tension. Refer to OVERVIEW - MUFFLER .

-- Add all wheel drive clutch oil and check the oil level in the all wheel drive clutch. Refer to Fill the All Wheel Drive Clutch Oil .