Fill the All Wheel Drive Clutch Oil

-- Place the :VAS6208  under the final drive.

-- To fill use the :VAS6291A  .

-- Remove the oil filler plug -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the adapter -A- and elbow -B-.

-- Install the adapter -A- all the way.

-- Lock the elbow -B- with the adapter -A-.

-- Route the Charging Device hose over the drive axle.

• The hose must not sag. It must enter above left rear wheel on vehicle.

-- Lower the vehicle.

-- Make sure the valve -arrow- is closed.

-- Attach the oil container -A- to the :VAS6291A  .

-- Open the valve -arrow- and hold the oil container as shown.

The all wheel drive clutch is now filled.

• When the all wheel drive clutch is filled properly, oil escapes at adapter -A-.
  Fig 3: Connecting Adapter & Elbow

  Courtesy of AUDI OF AMERICA, LLC

-- Raise the vehicle.

-- If oil escapes, place an oil container under the all wheel drive clutch (for example, on a workshop cart).

Overflowing oil now runs back into the oil container.

-- When the oil stops flowing, remove the :VAS6291A  .

• The all wheel drive clutch is not filled up to the lower edge of the oil filler hole.

-- Install a new oil filler plug -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Finally, check the oil level in the all wheel drive clutch. Refer to OIL LEVEL, CHECKING .

Tightening Specifications

• Oil filler plug for the all wheel drive clutch oil -Item  2-