Removing the Locating Pin: T10486/1
Removal is performed in the reverse order. Note the following:
-- Always only remove one locating pin and replace it with a new bolt.
CAUTION:
Improper handling increases the risk of damaging the threads in the vehicle body.
- Never use an impact wrench to loosen or tighten.
- Position the bolts by hand only and screw in the first threads.
-- A road test must be performed after completing repairs. If the steering wheel is crooked, the wheels must be aligned. Refer to AXLE ALIGNMENT .
Tightening Specifications
- Refer to OVERVIEW - SUBFRAME
- Refer to OVERVIEW - NOISE INSULATION .
- Refer to OVERVIEW - UNDERBODY TRIM PANELS .