Backrest Cover And Cushion, Removing And Installing, Standard/Sport Seat, Excluding A3 Sport Seat: Removing
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Secure the front seat to the Engine/Transmission Holder - Seat Repair Fixture: VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING .
-- Remove the headrest. Refer to HEADREST, REMOVING AND INSTALLING .
-- Disconnect the wiring harness connectors for the backrest and free up the disconnected wiring harnesses. Refer to WIRE ROUTING, DISCONNECTING AND CONNECTING .
-- Remove the front backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
-- Detach the molding -1, 2 and 3- at the backrest frame by hand or using the T-Handle Hook: 3438 .
-- Open the backrest cover on the clamping strips starting on the tunnel side.
-- To do this, press the front side of the cover -1- with the U-shaped profile inward in direction of -arrow A- and remove the rear side of the cover -2- with the flat channel in direction of -arrow B-.
-- If equipped, remove the clips/expanding rivets -arrows- using the Pry Lever: 80-200 .
-- Remove the front thorax airbag. Refer to FRONT THORAX AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
-- A3 driver seat: if necessary, remove the center airbag. Refer to Thorax Airbags .
-- Equipped on some models: free up the backrest heating wiring harness.
-- Loosen the cover and cushion from the backrest frame and remove them upward.