Wire Routing, Disconnecting And Connecting
- Follow the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Individual Wire, Removing
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Secure the front seat to the Engine/Transmission Holder - Seat Repair Fixture: VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- If equipped, unclip the rear bracket for the wire routing on the seat pan using a flat-head screwdriver.
-- Separate the cable holder -2 and 5- and cable tie -3 and 4-.
-- Remove the single wire from the protective cover -1-.
-- Replacing a faulty wire. Refer to WIRING HARNESSES AND CONNECTORS, REPAIRING .
Individual Wire, Installing
Install in the reverse order of removal while noting the following:
-- When bundling and placing individual wires, make sure the wires are not twisted.
- During installation, all cable ties, cable holders and clips must be installed at the same location.
- Slide the connectors on until they click into place.
-- Install the front seat. Refer to Installing .