Side Spoiler, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Check the foam seal -2- for damage.
- The vehicle and the spoiler must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the adhesive surfaces with Cleaning Solution and let it dry.
-- Fold back the ends of the protective film, or attach a pulling aid -5- to the protective film -3-.
-- Align the spoiler -4- on the rear lid -1- while paying attention to the adjustment dimension List Item: B - .
-- Remove the protective film from the adhesive tape.
-- Push on the spoiler until it engages audibly on the rear lid.
-- Push the entire length of the spoiler on using the Roller : T40400 .
- Resting time approximately 30 minutes at room temperature