Pistons, Removing And Installing: Removing

• The engine is secured to the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Mark the installation position and allocation:

• Pistons to cylinder.
• Connecting rod to cylinder -item  4-.
• Connecting rod bearing cap to connecting rod -item  2-.

-- Remove the bolts -arrows- and remove the connecting rod bearing cap -1-.

Courtesy of AUDI OF AMERICA, LLC

• Do not damage the cracked surfaces of the connecting rods and connecting rod bearing caps.

-- Remove the piston with the connecting rod upward.

TIP:

Fig 1: Locating Components of Piston

Courtesy of AUDI OF AMERICA, LLC

If difficult to move, heat the pistons to approximately 60 °C (140 °F).

-- Remove the circlip -2- from the piston pin eye.

-- Remove the piston pin -3- using the :VW222A  .

-- Remove the pistons -1- from the connecting rod -4-.