Spring Element For Bumper Cover Bracket, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, and 2021 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
Market-Specific:
-- Engage the support -1- with the lower support on the impact member -2- and then pivot upward in direction of -arrow-.
- The tab -4- in the support must at the same time engage in the edge -3- of the impact member.
Continuation:
-- Rivet the spring element or support with the spring element using the rivets.
-- Push the spring element all the way down and tighten the bolt.
-- Adjust the spring element. Refer to Height, Adjusting Using Spring Element .