Impact Member Mount, Removing and Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the connector -1- on the horn -2- and free up the wiring harness -3-.
-- Remove the screws -arrows-.
-- Remove the bolts -1 and 4-.
-- Pull the lock carrier -3- slightly forward, push the impact member mount -2- upward and out of the guide -5- in direction of -arrow- and remove it to the side.
Installing
Install in reverse order of removal and note the following:
-- Adjust the spring element. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .
Tightening Specifications
- Refer to OVERVIEW - IMPACT MEMBER
- Refer to OVERVIEW - LOCK CARRIER