Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

If the drive plate was removed or replaced, the sensor wheel function must be checked before installation. Refer to SENSOR WHEEL, CHECKING .
Replace the bolts that were tightened with an additional turn after removing them.

-- Pay attention to the alignment pin when installing the drive plate.

-- Reposition the : 10-201 to tighten the bolts.