Overview - SUBFRAME Mount

Engine Mount 

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

1. Subframe
2. Bolt
   • 20 Nm
   • For the 2.9L engine
3. Bolt
   • 10 Nm
   • For the 2.9L engine
4. Engine Support
   • Only right for the 2.9L engine
   • Removing and Installing. Refer to ENGINE SUPPORT BEARING, REMOVING AND INSTALLING .
   • Installation position. Refer to Fig 2.
5. Bolt
   • 55 Nm
6. Engine Support
   • Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
7. Not Installed
8. Not Installed
9. Bolt
   • 55 Nm
10. Engine Mount
    • With:
      • Left Electrohydraulic Engine Mount Solenoid Valve -N144-
      • Right Electrohydraulic Engine Mount Solenoid Valve -N145-
    • Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
11. Bolt
    • 90 Nm + 90°
    • Always replace after removing.
12. Bolt
    • 30 Nm

Engine Support - Installation Position 

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

• The raised section -2- of the engine support must engage into the opening -1- on the engine support bearing.

Transmission Mount 

Fig 3: Exploded View Of Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
2. Tunnel Crossmember
   • Removing and Installing. Refer to the appropriate Service Information .
3. Nut
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
4. Transmission Support
   • Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
5. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
6. Transmission Mount
   • Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
7. Stop
   • For the transmission mount
8. Bolt
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support
9. Nut
   • Tightening specifications. Refer to the appropriate Service Information .
   • Only remove when the transmission mount must be separated from the transmission support