Transmission Mount, Removing And Installing

WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Support, Removing with Transmission Mount

-- Remove the tunnel crossmember. Refer to the appropriate Service Information .

-- Remove the bolts -arrows- and remove the transmission support -1- with the transmission mount from the transmission.

Courtesy of AUDI OF AMERICA, LLC

Transmission Mount, Removing and Installing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and remove the stop -2- for the transmission mount.

-- Remove the nut -5- and remove the transmission mount -3- from the transmission support -4-. (The transmission support does not correspond to the version in the vehicle.)

Installing

Install in reverse order of removal and note the following:

-- Tighten the nut -5- hand-tight.

-- Tighten the bolts -1- and then the nut -5-.

-- Install the transmission support with the transmission mount.

Tightening Specifications

Refer to the appropriate Service Information .