Part II
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item 4-
- Tensioning Bracket
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut. Refer to -item 15-
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item 4-
- Oil Return Line
- Replace after removing.
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item 9-
- Seal
- Replace after removing.
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item 12-
- Seal
- Replace after removing.
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 20-