Right Seal, Replacing

Special tools and workshop equipment required

Pay attention to the general information. Refer to REPAIR INFORMATION .
Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Pay attention to the general repair information. Refer to GENERAL REPAIR INFORMATION .

Procedure

-- Remove the right flange shaft. Refer to the appropriate Service Information .

-- Remove the right seal using the Puller - Crankshaft/Power Steering Seal : T20143/2 .

-- Coat the outer edge and sealing lips on the new seal with transmission fluid.

Fig 1: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct sealing grease.

-- Drive the new seal all the way in using the : T10049 . Do not tilt it while doing so.

Fig 2: Driving In New Sealing Ring To Stop Using Thrust Piece T10049

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft. Refer to the appropriate Service Information .

-- Checking gear oil level. Refer to GEAR OIL, CHECKING LEVEL .