Overview - SUBFRAME Mount

Fig 1: Subframe Mount Exploded View

Courtesy of AUDI OF AMERICA, LLC

1. 1 - Bolt
   • 40 Nm +90°
   • Always replace after removing.
2. 2 - Engine Mount
   • With support arm
   • Adjustment, checking. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT 
   • Adjusting. Refer to SUBFRAME MOUNT, ADJUSTING .
   • Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
3. 3 - Bolt
   • 40 Nm +90°
   • Always replace after removing.
4. 4 - Bolt
   • 40 Nm +90°
   • Always replace after removing.
5. 5 - Bolt
   • 20 Nm +90°
   • Always replace after removing.
6. 6 - Bolt
   • 40 Nm +90°
   • Always replace after removing.
7. 7 - Bolt
   • Tightening specification and sequence. Refer to Fig 2.
8. 8 - Pendulum Support
   • Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
9. 9 - Bolt
   • Tightening specification and sequence. Refer to Fig 2.
10. 10 - Bolt
    • Tightening specification and sequence. Refer to Fig 2.
11. 11, 12 - Bolts
    • Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT .
12. 13 -

    Transmission Mount

    • Adjustment, checking. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT 
    • Adjusting. Refer to SUBFRAME MOUNT, ADJUSTING .
    • Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .

Pendulum Support - Tightening Specifications and Sequence

Fig 2: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

• Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence: