Overview - Cylinder Block, Transmission Side

• For assembly work secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of AUDI

1. Bolt
   • Replace after removing
   • 60 Nm +90°
2. Drive Plate
   • With the bearing flange
   • Check the contact surfaces on the bearing flange and the torque converter holes for cracks and wear grooves.
   • Removing and Installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
3. Sensor Wheel
   • For the Engine Speed Sensor -G28-
   • Removing and Installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
   • Check using the Vehicle Diagnostic Tester Refer to SENSOR WHEEL, CHECKING .
   • After removing and installing or replacing perform the listed adaptation in the 0001 - Engine Electronics Functions "0001 - Steps after replacing components" using the Vehicle Diagnostic Tester.
4. Seal
   • For the crankshaft on the transmission side
   • Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
5. Alignment Pin
6. Crankshaft
   • Overview. Refer to OVERVIEW - CRANKSHAFT .