Flywheel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Attaching Puller - Clutch Module T40176 To Clutch Module -A-

Courtesy of AUDI OF AMERICA, LLC

There is a normal >>clicking<< in the dual mass flywheel with "LuK" centrifugal pendulum absorber -A-.

Fig 2: Turning Clutch Module -A- With Centrifugal Pendulum Absorber 90 Degrees (Clicking Noise Normal)
Courtesy of AUDI OF AMERICA, LLC
A >>clicking<< is heard when turning the clutch module -A- approximately every 90°. This noise comes from shifting pendulum masses (centrifugal pendulum absorber) in the dual mass flywheel and is not a fault.

-- Secure the transmission on the : VAS6095 . Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Attach the : T40176 to the flywheel -A- with the nut -B- -arrow-.

Fig 3: Identifying Flywheel Components, Remove/Install

Courtesy of AUDI OF AMERICA, LLC

-- Turn the : T40176 upward.

Tip:

To prevent the flywheel from tipping, counterhold on the bottom of the flywheel.

-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.