Securing On Engine And Transmission Holder

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Shop Crane: VAS6100
Engine and Gearbox Bracket: VAS6095A
Transmission with Three-Phase Current Drive -VX54- (0DK)Transmission Holder: T40407
Transmission without Three-Phase Current Drive -VX54- (0CJ, 0CL, 0CK, 0DN, 0DP, 0HL) either Transmission Support: T40206 or Transmission Holder: T40407

Procedure

-- Insert the Transmission Holder: T40407 in the Engine and Transmission Holder: VAS6095A .

CAUTION:

Risk of damaging the transmission by mixing ATF and transmission fluid (MTF) through the same bleeder.

- The transmission filled with ATF and (MTF) transmission fluid must be tilted a maximum of 15° in lateral and longitudinal direction.

- If more of an incline is needed, then the ATF and MTF transmission fluids must be drained.

- Drain the ATF. Refer to the appropriate service information. .

- Drain the transmission fluid. Refer to the appropriate service information. .

Transmission Maximum Tilt

Fig 1: Transmission Maximum Tilt

Courtesy of AUDI OF AMERICA, LLC

-- Insert the : T40407 in the : VAS6095A .

-- Lift the transmission using the : T40406 -1-. Refer to TRANSMISSION, TRANSPORTING .

Fig 2: NO CONTENT

Courtesy of AUDI OF AMERICA, LLC

-- Guide together the transmission using the : T40407 -2- and tighten.

Bolt -arrow A- = M10 X 80 "8.8"

Bolt -arrow B- = M10 X 120 "8.8"

Bolt -arrow C- = M10 X 50 "8.8"