Rear Lower Transverse Link, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Install the threaded connections up to the stop but do not tighten yet.

• Bonded rubber bushings have a limited range of rotation. Only tighten the suspension bolts when the vehicle is in curb weight position or at standard vehicle height.

-- Lifting the wheel bearing in curb weight position (refer to WHEEL BEARING, LIFTING TO CURB WEIGHT POSITION, VEHICLES WITH COIL SPRING ) or at standard vehicle height (refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION ).

-- Install the impact guard if necessary. Refer to Figure.

-- Versions with coil springs: install the spring. Refer to SPRING, REMOVING AND INSTALLING .

-- Versions with air suspension: fill the air suspension system. Refer to AIR SUSPENSION SYSTEM, FILLING AND BLEEDING .

• Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .